ZunTzu

Posted: **22 Jan 2009, 03:22**

What is wrong with this code?

       	<counter-sheet name="Cards" front-image-file="Cards.jpg" front-mask-file="Cards.png"
                back-image-file="Cardsback.jpg" back-mask-file="Cards.png">
		<card-section rows="4" columns="4"
			face-left="0" face-top="0" face-right="1050" face-bottom="1500"
			back-left="0" back-top="0" back-right="1050" back-bottom="1500" />
		</counter-sheet>

What this produces is a deck of 16 cards, each with the proper front face. The back face, however, is the entire card sheet all over again. Doesn't the back-image-file make the default image for the back the image shown? The back image for the card set is never used at all.

Posted: **22 Jan 2009, 10:20**

Do you want each card to have a different back? (I'm not sure if that can be done as with counters)

This is my code:

Code: Select all

	<counter-sheet name="Catholic Cards"
		front-image-file="cards-cath.jpg" front-mask-file="cards-mask.png">
		<card-section rows="5" columns="11"
			face-left="0" face-top="0" face-right="3080" face-bottom="2000"
			back-left="3080" back-top="0" back-right="3360" back-bottom="400"/>
	</counter-sheet>

As you can see, I point for the back to a specific location in the same (single) cards bitmap.
I assume that cards can have only one image file, unlike counters.

But I'm not the expert, just my two cents.

Posted: **23 Jan 2009, 04:16**

Yeah, I figured it out. I switched to using the card tag, but didn't alter the image to show the back on the same sheet. It's just one stupid mistake after another, sometimes.

Thanks, though!

ZunTzu

Card back problems

Card back problems